 |
|
252 lb. Allowable working load (4:1 safety factor) |
| | |
Strong, reliable attachment of pre-tied hanger wire |
| | |
Use for open web bar joists or purlins |
| | |
Each clip fits 1/16"-1/4" flanges |
| |
EASY INSTALLATION |
| 1. |
Attach a 1/2" pipe extension (dielectric pole available) to the threaded end of a J-Master tool, and place pre-wired J-Clip into tool. |
| 2. |
Insert the J-Clip up into the void between the two base angles. Position
the clips over the vertical flange and pull |
| 3. |
Disengage the tool by lifting up and out. |
 |
 |
| 
J-Clip
attached to the
J-Master Tool |
|
|
|
|
|
217 lb. Allowable working load (4:1 safety factor) |
| | |
Fast, easy attachment of pre-tied hanger wire from Z-Purlins |
| | |
Disengages from J-Master tool after installation |
| | |
Two magnetic strips attached to J-Master tool make installation easy |
| |
EASY INSTALLATION |
| 1. |
Attach J-Master tool to end of threaded 1/2" pipe or dielectric pole. Lay pre-tied Clip-Pur against magnetized strips. |
| 2. |
Raise the Clip-Pur up to the purlin. Position the clip on the 45°
flange and give a downward tug, the clip is now in position. |
| 3. |
Disengage the tool by lifting up and out. |
|
|
|
